ZPOOL-ATTACH(8)

NAME
zpool-attach - attach new device to existing ZFS vdev

SYNOPSIS
zpool attach [-fsw] [-o property=value] pool vdev new_device

DESCRIPTION
Attaches new_device to the existing vdev. The behavior differs depending on if the existing vdev is a RAID-Z device, or a mirror/plain device.

If the existing vdev is a mirror or plain device (e.g. specified as "sda" or "mirror-7"), the new device will be mirrored with the existing vdev, a resilver will be initiated, and the new device will contribute to additional redundancy once the resilver completes. If vdev is not currently part of a mirrored configuration, device automatically transforms into a two-way mirror of device and new_device. If vdev is part of a two-way mirror, attaching new_device creates a three-way mirror, and so on. In either case, new_device begins to resilver immediately and any running scrub is canceled.

If the existing vdev is a RAID-Z device (e.g. specified as "raidz2-0"), the new device will become part of that RAID-Z group. A "raidz expansion" will be initiated, and once the expansion completes, the new device will contribute additional space to the RAID-Z group. The expansion entails reading all allocated space from existing disks in the RAID-Z group, and rewriting it to the new disks in the RAID-Z group (including the newly added device). Its progress can be monitored with zpool status.

Data redundancy is maintained during and after the expansion. If a disk fails while the expansion is in progress, the expansion pauses until the health of the RAID-Z vdev is restored (e.g. by replacing the failed disk and waiting for reconstruction to complete). Expansion does not change the number of failures that can be tolerated without data loss (e.g. a RAID-Z2 is still a RAID-Z2 even after expansion). A RAID-Z vdev can be expanded multiple times.

After the expansion completes, old blocks retain their old data-to-parity ratio (e.g. 5-wide RAID-Z2 has 3 data and 2 parity) but distributed among the larger set of disks. New blocks will be written with the new data-to-parity ratio (e.g. a 5-wide RAID-Z2 which has been expanded once to 6-wide, has 4 data and 2 parity). However, the vdev's assumed parity ratio does not change, so slightly less space than is expected may be reported for newly-written blocks, according to zfs list, df, ls -s, and similar tools.

A pool-wide scrub is initiated at the end of the expansion in order to verify the checksums of all blocks which have been copied during the expansion.

-f  Forces use of new_device, even if it appears to be in use. Not all vdevs can be overridden in this manner.

-o property=value
    Sets the given pool properties. See the zpoolprops(7) manual page for a list of valid properties that can be set. The only property supported at the moment is ashift.

-s  When attaching to a mirror or plain vdev, the new_device is reconstructed sequentially to restore redundancy as quickly as possible. Checksums are not verified during sequential reconstruction so a scrub is started when the resilver completes.

-w  Waits until new_device has finished resilvering or expanding before returning.

SEE ALSO
zpool-add(8), zpool-detach(8), zpool-import(8), zpool-initialize(8), zpool-online(8), zpool-replace(8), zpool-resilver(8)