247 lines
6.4 KiB
C
247 lines
6.4 KiB
C
// SPDX-License-Identifier: GPL-2.0+
|
|
/*
|
|
* Azoteq IQS620A PWM Generator
|
|
*
|
|
* Copyright (C) 2019 Jeff LaBundy <jeff@labundy.com>
|
|
*
|
|
* Limitations:
|
|
* - The period is fixed to 1 ms and is generated continuously despite changes
|
|
* to the duty cycle or enable/disable state.
|
|
* - Changes to the duty cycle or enable/disable state take effect immediately
|
|
* and may result in a glitch during the period in which the change is made.
|
|
* - The device cannot generate a 0% duty cycle. For duty cycles below 1 / 256
|
|
* ms, the output is disabled and relies upon an external pull-down resistor
|
|
* to hold the GPIO3/LTX pin low.
|
|
*/
|
|
|
|
#include <linux/device.h>
|
|
#include <linux/kernel.h>
|
|
#include <linux/mfd/iqs62x.h>
|
|
#include <linux/module.h>
|
|
#include <linux/mutex.h>
|
|
#include <linux/notifier.h>
|
|
#include <linux/platform_device.h>
|
|
#include <linux/pwm.h>
|
|
#include <linux/regmap.h>
|
|
#include <linux/slab.h>
|
|
|
|
#define IQS620_PWR_SETTINGS 0xd2
|
|
#define IQS620_PWR_SETTINGS_PWM_OUT BIT(7)
|
|
|
|
#define IQS620_PWM_DUTY_CYCLE 0xd8
|
|
|
|
#define IQS620_PWM_PERIOD_NS 1000000
|
|
|
|
struct iqs620_pwm_private {
|
|
struct iqs62x_core *iqs62x;
|
|
struct pwm_chip chip;
|
|
struct notifier_block notifier;
|
|
struct mutex lock;
|
|
unsigned int duty_scale;
|
|
};
|
|
|
|
static int iqs620_pwm_init(struct iqs620_pwm_private *iqs620_pwm,
|
|
unsigned int duty_scale)
|
|
{
|
|
struct iqs62x_core *iqs62x = iqs620_pwm->iqs62x;
|
|
int ret;
|
|
|
|
if (!duty_scale)
|
|
return regmap_clear_bits(iqs62x->regmap, IQS620_PWR_SETTINGS,
|
|
IQS620_PWR_SETTINGS_PWM_OUT);
|
|
|
|
ret = regmap_write(iqs62x->regmap, IQS620_PWM_DUTY_CYCLE,
|
|
duty_scale - 1);
|
|
if (ret)
|
|
return ret;
|
|
|
|
return regmap_set_bits(iqs62x->regmap, IQS620_PWR_SETTINGS,
|
|
IQS620_PWR_SETTINGS_PWM_OUT);
|
|
}
|
|
|
|
static int iqs620_pwm_apply(struct pwm_chip *chip, struct pwm_device *pwm,
|
|
const struct pwm_state *state)
|
|
{
|
|
struct iqs620_pwm_private *iqs620_pwm;
|
|
unsigned int duty_cycle;
|
|
unsigned int duty_scale;
|
|
int ret;
|
|
|
|
if (state->polarity != PWM_POLARITY_NORMAL)
|
|
return -EINVAL;
|
|
|
|
if (state->period < IQS620_PWM_PERIOD_NS)
|
|
return -EINVAL;
|
|
|
|
iqs620_pwm = container_of(chip, struct iqs620_pwm_private, chip);
|
|
|
|
/*
|
|
* The duty cycle generated by the device is calculated as follows:
|
|
*
|
|
* duty_cycle = (IQS620_PWM_DUTY_CYCLE + 1) / 256 * 1 ms
|
|
*
|
|
* ...where IQS620_PWM_DUTY_CYCLE is a register value between 0 and 255
|
|
* (inclusive). Therefore the lowest duty cycle the device can generate
|
|
* while the output is enabled is 1 / 256 ms.
|
|
*
|
|
* For lower duty cycles (e.g. 0), the PWM output is simply disabled to
|
|
* allow an external pull-down resistor to hold the GPIO3/LTX pin low.
|
|
*/
|
|
duty_cycle = min_t(u64, state->duty_cycle, IQS620_PWM_PERIOD_NS);
|
|
duty_scale = duty_cycle * 256 / IQS620_PWM_PERIOD_NS;
|
|
|
|
if (!state->enabled)
|
|
duty_scale = 0;
|
|
|
|
mutex_lock(&iqs620_pwm->lock);
|
|
|
|
ret = iqs620_pwm_init(iqs620_pwm, duty_scale);
|
|
if (!ret)
|
|
iqs620_pwm->duty_scale = duty_scale;
|
|
|
|
mutex_unlock(&iqs620_pwm->lock);
|
|
|
|
return ret;
|
|
}
|
|
|
|
static int iqs620_pwm_get_state(struct pwm_chip *chip, struct pwm_device *pwm,
|
|
struct pwm_state *state)
|
|
{
|
|
struct iqs620_pwm_private *iqs620_pwm;
|
|
|
|
iqs620_pwm = container_of(chip, struct iqs620_pwm_private, chip);
|
|
|
|
mutex_lock(&iqs620_pwm->lock);
|
|
|
|
/*
|
|
* Since the device cannot generate a 0% duty cycle, requests to do so
|
|
* cause subsequent calls to iqs620_pwm_get_state to report the output
|
|
* as disabled. This is not ideal, but is the best compromise based on
|
|
* the capabilities of the device.
|
|
*/
|
|
state->enabled = iqs620_pwm->duty_scale > 0;
|
|
state->duty_cycle = DIV_ROUND_UP(iqs620_pwm->duty_scale *
|
|
IQS620_PWM_PERIOD_NS, 256);
|
|
|
|
mutex_unlock(&iqs620_pwm->lock);
|
|
|
|
state->period = IQS620_PWM_PERIOD_NS;
|
|
state->polarity = PWM_POLARITY_NORMAL;
|
|
|
|
return 0;
|
|
}
|
|
|
|
static int iqs620_pwm_notifier(struct notifier_block *notifier,
|
|
unsigned long event_flags, void *context)
|
|
{
|
|
struct iqs620_pwm_private *iqs620_pwm;
|
|
int ret;
|
|
|
|
if (!(event_flags & BIT(IQS62X_EVENT_SYS_RESET)))
|
|
return NOTIFY_DONE;
|
|
|
|
iqs620_pwm = container_of(notifier, struct iqs620_pwm_private,
|
|
notifier);
|
|
|
|
mutex_lock(&iqs620_pwm->lock);
|
|
|
|
/*
|
|
* The parent MFD driver already prints an error message in the event
|
|
* of a device reset, so nothing else is printed here unless there is
|
|
* an additional failure.
|
|
*/
|
|
ret = iqs620_pwm_init(iqs620_pwm, iqs620_pwm->duty_scale);
|
|
|
|
mutex_unlock(&iqs620_pwm->lock);
|
|
|
|
if (ret) {
|
|
dev_err(iqs620_pwm->chip.dev,
|
|
"Failed to re-initialize device: %d\n", ret);
|
|
return NOTIFY_BAD;
|
|
}
|
|
|
|
return NOTIFY_OK;
|
|
}
|
|
|
|
static const struct pwm_ops iqs620_pwm_ops = {
|
|
.apply = iqs620_pwm_apply,
|
|
.get_state = iqs620_pwm_get_state,
|
|
};
|
|
|
|
static void iqs620_pwm_notifier_unregister(void *context)
|
|
{
|
|
struct iqs620_pwm_private *iqs620_pwm = context;
|
|
int ret;
|
|
|
|
ret = blocking_notifier_chain_unregister(&iqs620_pwm->iqs62x->nh,
|
|
&iqs620_pwm->notifier);
|
|
if (ret)
|
|
dev_err(iqs620_pwm->chip.dev,
|
|
"Failed to unregister notifier: %d\n", ret);
|
|
}
|
|
|
|
static int iqs620_pwm_probe(struct platform_device *pdev)
|
|
{
|
|
struct iqs62x_core *iqs62x = dev_get_drvdata(pdev->dev.parent);
|
|
struct iqs620_pwm_private *iqs620_pwm;
|
|
unsigned int val;
|
|
int ret;
|
|
|
|
iqs620_pwm = devm_kzalloc(&pdev->dev, sizeof(*iqs620_pwm), GFP_KERNEL);
|
|
if (!iqs620_pwm)
|
|
return -ENOMEM;
|
|
|
|
iqs620_pwm->iqs62x = iqs62x;
|
|
|
|
ret = regmap_read(iqs62x->regmap, IQS620_PWR_SETTINGS, &val);
|
|
if (ret)
|
|
return ret;
|
|
|
|
if (val & IQS620_PWR_SETTINGS_PWM_OUT) {
|
|
ret = regmap_read(iqs62x->regmap, IQS620_PWM_DUTY_CYCLE, &val);
|
|
if (ret)
|
|
return ret;
|
|
|
|
iqs620_pwm->duty_scale = val + 1;
|
|
}
|
|
|
|
iqs620_pwm->chip.dev = &pdev->dev;
|
|
iqs620_pwm->chip.ops = &iqs620_pwm_ops;
|
|
iqs620_pwm->chip.npwm = 1;
|
|
|
|
mutex_init(&iqs620_pwm->lock);
|
|
|
|
iqs620_pwm->notifier.notifier_call = iqs620_pwm_notifier;
|
|
ret = blocking_notifier_chain_register(&iqs620_pwm->iqs62x->nh,
|
|
&iqs620_pwm->notifier);
|
|
if (ret) {
|
|
dev_err(&pdev->dev, "Failed to register notifier: %d\n", ret);
|
|
return ret;
|
|
}
|
|
|
|
ret = devm_add_action_or_reset(&pdev->dev,
|
|
iqs620_pwm_notifier_unregister,
|
|
iqs620_pwm);
|
|
if (ret)
|
|
return ret;
|
|
|
|
ret = devm_pwmchip_add(&pdev->dev, &iqs620_pwm->chip);
|
|
if (ret)
|
|
dev_err(&pdev->dev, "Failed to add device: %d\n", ret);
|
|
|
|
return ret;
|
|
}
|
|
|
|
static struct platform_driver iqs620_pwm_platform_driver = {
|
|
.driver = {
|
|
.name = "iqs620a-pwm",
|
|
},
|
|
.probe = iqs620_pwm_probe,
|
|
};
|
|
module_platform_driver(iqs620_pwm_platform_driver);
|
|
|
|
MODULE_AUTHOR("Jeff LaBundy <jeff@labundy.com>");
|
|
MODULE_DESCRIPTION("Azoteq IQS620A PWM Generator");
|
|
MODULE_LICENSE("GPL");
|
|
MODULE_ALIAS("platform:iqs620a-pwm");
|